Loading ...
Loading ...
Loading ...
11
OPTIONS CAN BE
SELECTED
WHAT IT DOES ADDED TIME
TO CYCLE
ADDED
WATER
GALLONS
(LITERS)
Dries dishes with heat and a fan. This option,
with the use of rinse aid, will provide optimum
drying performance. Plastic items are less likely
to deform when loaded in the top rack. Turn off all
Fan Dry options for air dry.
Auto
PowerBlast
®
Normal
Quick
Uses a heating
element and fan
to speed drying
times. Short
Power Dry option
is on when any
cycle is selected
except for Quick
and Rinse.
0:11 to 0:46 NA
Uses heat and a fan for additional time to dry
dishes. For the very best drying performance, use
rinse aid and the Long Power Dry option. Turn off
all Fan Dry options for air dry.
Auto
PowerBlast
®
Normal
Quick
Lengthens the
time that Long
Power Dry is
active.
0:43 to 1:20 NA
Runs dishwasher at a later time or during off-peak
electrical hours. Select a wash cycle and options.
Press DELAY to cycle through the delay time
options. Press START. Close door rmly.
NOTE: Any time the door is opened (such as, to
add a dish), the START keypad must be touched
again to resume the delay countdown.
Available with
any cycle
Delays start of a
cycle by 8 hours.
CONTROL PURPOSE COMMENTS
Press to START
a wash cycle.
If the door is opened during a cycle or the power is interrupted, the START
button light ashes. Cycle will not resume until START is pressed and
the door is closed. Push door rmly closed within 4 seconds of pressing
START.
Press to cancel
wash cycle
Press and hold CANCEL for 3 seconds. Close the door rmly. The
dishwasher starts a 2-minute drain (if needed). Let dishwasher drain
completely.
The display
allows you
to follow the
progress of the
dishwasher
cycle.
Your dishwasher has indicators that glow for Add Dish, Washing, Drying,
Sanitized and Clean.
The exterior status light on the front of the door panel will glow blue when
washing, red while it is drying, and white when the cycle is complete.
Canceling A Cycle
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop before completely opening the door.
2. Press CANCEL. The Cancel indicator will glow.
3. Close the door and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the dishwasher
drain completely. The Cancel indicator turns off after 2
minutes.
Changing A Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed.
a. If cover is open cancel the cycle and start a new cycle
b. If cover is closed continue to next step
3. Press CANCEL twice to reset the control.
4. Select new cycles and options.
5. Press START.
Adding A Dish With Add A Dish Indicator
1. If Add a Dish indicator is lit. proceed to Step 2. If indicator is
not lit an added dish might not get cleaned.
2. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, and then open the door completely.
3. Add the dish.
4. Press START keypad and close the door within 4 seconds to
resume the cycle.
Short
Power
Dry
Models)
Long
Power
Dry
Models)
D
CONTROLS AND CYCLE STATUS
Hold 3 Sec
Loading ...
Loading ...
Loading ...