Loading ...
Loading ...
Loading ...
22
ELECTRIC DRYER ELECTRICAL CONNECTIONS
(FOR U.S.A. ONLY)
Connecting 4-Wire Connection: Direct Wire
IMPORTANT: A 4-wire connection is required where local codes
do not permit the use of 3-wire connections.
Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer
can be moved if needed.
Strip 5" (127 mm) of outer covering from end of cable, leaving
bare ground wire at 5" (127 mm). Cut 1½" (38 mm) from three
remaining wires. Strip insulation back 1" (25 mm). Shape ends of
wires into a hook shape.
Connecting Neutral Ground and Neutral Wires
1. Remove center terminal block screw (A) and neutral ground
wire (B) by removing the external ground connector screw (C).
2. Connect neutral ground (B) and place hooked end (hook
facing right) of neutral wire (white or center wire) cable (D)
under center terminal block screw (B). Squeeze hooked end
together. Tighten screw.
Connecting Direct Wire Ground
3. Connect ground wire (green or bare) (E) with external ground
connector screw (C). Tighten screw.
Connecting Remaining Wires
4. Place hooked ends of remaining direct wire cables (hooks
facing right). Squeeze hooded ends together and tighten
outer terminal block screws (F). screws. Finally, re-install
terminal block cover and tighten hold-down screw. Tighten
screws. Go to “Complete Installation” section.
C
A
B
r
B
D
E
C
F
F
Loading ...
Loading ...
Loading ...