Loading ...
Loading ...
Loading ...
38
CARE AND CLEANING
Removing the Drawer
Disconnect the electrical power to the range at the
main fuse or circuit breaker panel before removing
the drawer. Failure to do so can result in severe
personal injury, death, or electrical shock.
WARNING
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further cleaning
is needed. Use warm water to thoroughly clean.
1. Fully open the drawer.
2. Remove the two screws.
Remove screws
3. Locate the glide lever on each side of the drawer.
Push down on the left glide lever and pull up on the
right glide lever.
Lever
Lever
Push down with finger Pull up with finger
4. Pull the drawer away from the range.
Replacing the Drawer
1. Pull the bearing glides to the front of the chassis
glide.
2. Align the glide on each side of the drawer with the
glide slots on the range.
3. Push the drawer into the range until levers “click ”
(approximately 2 inches).
4. Pull the drawer open again to seat the bearing glides
into position.
5. Replace the two screws.
OPTIONAL REAR FILLER
If the counter does not bridge the opening at the rear
wall the rear filler kit, that is provided with the slide in
range, will be needed.
If the countertop depth is greater than 25” there
will be a gap between the filler kit and the back wall.
NOTE
If the countertop depth is less than 24”, the control panel
will not sit flush with the countertop.
Loading ...
Loading ...
Loading ...