Loading ...
Loading ...
Loading ...
3
Removing transportation bolt
– Before using the appliance for the first time, always remove and retain
all 4 transportation bolt at the back of appliance.
– Be careful when you handle it and avoid injuring.
For WM,WAX,WAE
1. Release all fixing bolts A by spanner.
2. Remove the four parts B. They will fall to the floor
when you tip the machine.
3. Insert the cover caps C which you will find in the
bag containing the documentation.
For WS,WLX
1. Loosen the four bolts by spanner until they are
freely movable, remove them.
2. Insert the cover caps which you will find in the bag
containing the documentation.
D
C
4
Water connection
– To prevent leakage or water damage, follow the instructions in this chapter!
– Attention: Operate the washing machine with cold water only.
Do not connect to a mixer tap of a pressureless hot-water heater.
– Do not disassemble the warter inlet hose frequently, the untight connection will lead to
leakage. We suggest that you use a water inlet hose specially for the machine.
– Do not use a used inlet hose. Only use the inlet hose supplied or one whih was purchased
from an authorised specialist dealer.
– If in doubt, have the appliance connected by a technician.
Water supply
Water inlet hose:
Attention: do not kink, crush, modify or cut through(strength is no longer guaranteed).
Optimum water pressure in the mains: 100-1000 kPa (1-10 bar)
– When the tap is turned on, the water flow should be more than 8l/min.
– If the water pressure is too high, install a pressure reducing valve.
1. Connect water inlet hose to the tap.
Tighten plastic screw-fittings by hand only.
2. Carefully turn on the tap and check that the connection
points are not leaking.
Attention: screw connection is under water mains
pressure.
Call customer service to get the plastic connector freely. It may connect
tightly the water inlet hose and your water tap.
Available from dealer/customer service:
– Special water tap fof machine.
– Extended water inlet hose.
Water drainage
Water drainage hose:
Attention: do not kink stretch.
Height difference between installation area and outlet: max. 100 cm
Drainage into a sink/bath tub:
Attention: Secure the drainage hose to prevent it from slipping out of
the sink.
Attention: The plug must not be in the plug hole. When the water is being
pumped out of the washing machine, check that the water drains away
quickly enough. Do not insert the end of the drainage hose into the pumped
off water! There is a risk that water will be drawn back into the washing
machine!
Drainage into a siphon:
Attention: Secure connection point with hose clip, Ø 24-40 mm.
min10mm
Loading ...
Loading ...