Loading ...
Loading ...
Loading ...
PRACTICAL INFORMATION
140
BATTERY
To charge the battery using a battery charger:
– Disconnect the battery,
– Follow the instructions for use given by the battery charger manufacturer,
– Reconnect starting with the negative (–) terminal,
– Check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
– Connect the red cable to the positive (+) terminals of the two batteries,
– Connect one end of the green or black cable to the negative (–) terminal of the
slave battery,
– Connect the other end of the green or black cable to an earth point on the bro-
ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
– Before disconnecting the battery, you must wait for 2 minutes after
switching off the ignition.
– Never disconnect a terminal when the engine is running.
– Never charge a battery without first disconnecting the terminals.
– Close the windows and sunroof before disconnecting the battery. If they do
not operate normally following reconnection of the battery, they must be
reintialised (see sections "Electric windows - Safety auto-reverse" and
"Sunroof - Safety auto-reverse".
– After every reconnection of the battery, switch on the ignition and wait
1 minute before starting to allow the electronic systems to be initialised. If
slight difficulties are experienced after this, please contact a PEUGEOT
dealer.
It is advisable to disconnect the battery if the vehicle is not to be used
for a period of more than one month.
ECONOMY MODE FUNCTION
After the engine has stopped, with
the key in the accessories position,
certain functions (windscreen wiper,
electric windows, courtesy lights,
audio equipment etc.) can only be
used for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the
message "Economy mode active"
appears on the multifunction display
and the active functions are put on
standby.
A flat battery will prevent the engine
from starting.
26-05-2003
Loading ...
Loading ...
Loading ...