Loading ...
Loading ...
Loading ...
44
Failure indicator
lights up
Display
message
Possible Cause Possible Solution
FdL
(or F29)
The door cannot unlock. Firmly press the door on the area of the
door lock, then press On/O for at least 3
seconds.
If hot cycle is selected, wait until cool
down and press again On/O for at least 3
seconds.
Switch on the washing machine. If failure
still appears, check and eventually remove
possible cause as indicated for failure
“Clean lter”. Then switch the washing
machine on again. If door does not unlock,
press On/O for at least 3 seconds.
If door still does not unlock, refer to
section “DOOR – HOW TO OPEN IT IN CASE
OF A FAILURE”. Before draining water /
opening the door, wait until the water has
cooled down (for hot wash programmes).
Call Service
F24
Too much laundry for a
programme with small
maximum load
Too much inlet water
Select and start programme “Rinse and
Spin” to complete the interrupted wash
programme.
Do not overload the washing machine.
Respect the maximum load size of the
programmes indicated in the Programme
Chart.
Turn o the water tap. Press On/O for at
least 3 seconds to drain the water; wait
until the drain phase has ended (End will
appear on display).
Turn on the water tap again. – If water
immediately ows into the washing
machine (without having started a
programme), there is a failure of an
electrical component. Close water tap,
switch o and unplug the washing
machine. Contact our After-Sales Service.
Call Service
F02
Water stop failure – water
leakage detected in
bottom tray.
Press Start/Pause. If problem persists, press
On/O for at least 3 seconds. If failure
persists, contact After-Sales Service.
Call Service
F04 to F99
Failure of an electrical
component
Press On/O button for at least 3 seconds
to reset the failure. If problem persists,
switch o washing machine, close the
water tap and unplug it; call After-Sales
Service.
Loading ...
Loading ...
Loading ...