Loading ...
Loading ...
Loading ...
43
EN
FAILURE INDICATORS AND MESSAGES
Below is a summary of possible failure causes and
solutions.
If the problem persists after having removed the
origin of the failure, press On/O for at least three
seconds. If afterwards the failure indication still
Failure Indicator
lights up
Display
message
Possible Cause Possible Solution
Open water
tap
No or not sucient water
supply
• Water tap closed
• Kinks in inlet hose
• Water tap pressure too
low
• Mesh lters in inlet hose
clogged
• Water inlet hose frozen
up
Open water tap
Make sure there are no kinks in the inlet
hose
Make sure water pressure is sucient
Clean mesh lters in inlet hose (CLEANING
AND MAINTENANCE)
Install washing machine at an ambient
temperature of at least 5°C
After problem has been removed, press
Start/Pause. If problem persists, press On/
O for at least 3 seconds.
Water lter
clogged
Waste water is not
pumped out
• Kinks in drain hose
• Drain hose blocked or
frozen up
• Filter blocked
• Pump blocked
Check drain hose for kinks
Install washing machine at an ambient
temperature of at least 5°C
Clean water lter as described in section
CLEANING THE FILTER.
After problem has been removed, press
Start/Pause. If problem persists, press On/
O for at least 3 seconds.
Over
foaming
Excessive foam formation
(maybe by overdosage
of detergent) interrupted
the programme. The
interruption can be
repeated several times
until the foam reduction
is sucient.
Start “Rinse&Spin” programme, with
option Intensive Rinse.
Respect the dosing recommendations by
the detergent manufacturer.
Adjust and use the Dosing Aid function.
Make sure that the water lter is clean.
Load
unbalance
Spin speed
“0” blinks
Unbalance in laundry
load prevented spin
cycle, to protect washing
machine
If you want to spin the wet laundry, add
more laundry items of dierent sizes and
start “Rinse&Spin”.
Avoid small laundry loads consisting of
few big, absorbent pieces of laundry. Wash
dierent sizes of articles in one load.
persists, close the water tap, switch o and unplug
the washing machine and contact our After-Sales
Service.
Indication on control panel Possible Cause Possible Solution
Door open indicator blinks
The door cannot lock Firmly press the door in area of door lock, to pro-
perly close it. Then press Start/Pause. If the problem
persists, press On/O for at least 3 seconds.
Loading ...
Loading ...
Loading ...