Loading ...
Loading ...
Loading ...
°C
°F
°F/
°C
RUN
Page 9
Installation
1
2
A
C
B
Reversing the Door Swing of Your
Appliance
This appliance has the capability of the
Ÿ
door opening from either the left or right
side. The unit is delivered to you with the
door opening from the left side. Should
you desire to reverse the opening
direction, please call service for reversal
instructions.
Installing stainless steel handle
This Beverage Cabinet includes a stainless
steel handle that is not required to operate
this unit.
To install the handle please follow the below
instructions:
For your convenience the screws used in the
installation of the handle have been put in
place at the factory.
Pull away the door gasket (A) in the area
Ÿ
where the handle is to be installed on the
left side as in Illustration #1. The gasket is
easily displaced by hand, no tools are
necessary.
Align the handle (B) with the screws
Ÿ
installed. Tighten the screws (C) using a
Phillips head screwdriver until the handle
sets both flush and secured tightly
against the door frame. (DO NOT over
tighten as this will cause damage to the
handle assembly).
Replace the door gasket (A) to its original
Ÿ
position.
If you choose not to use the handle
Ÿ
supplied, simply follow step 1 to access
the installation screws and remove them
and then place the two decorative plugs
into the two holes separately. Continue on
to step 3 to replace the door gasket to its
original position.
Clearances
Clearances required for the Beverage
Ÿ
Cabinet to adjacent surfaces are 10mm
from top and sides, and 50mm from rear.
10mm
(from top)
10mm
(from sides)
50mm (from rear)
Loading ...
Loading ...
Loading ...