Loading ...
Loading ...
Loading ...
Safety Precautions
4
Safety Precautions
Please take note of the safety instructions to prevent any potential accidents or misuse of the projector.
ꔈ Safety Instructions are given in two forms, i.e. 'Warning' and 'Notes' as detailed below.
Warning: The violation of this instruction may cause serious injury and even death.
Note: The violation of this instruction may cause injury or damage to the projector.
ꔈ Read the owner's manual carefully and keep it at hand.
Indoor Installation
Warning
Do not place the projector in direct
sunlight or near heat sources such
as radiators, fires, stoves etc.
There is a risk of fire.
Do not place flammable materials
such as aerosols near the projector.
There is a risk of fire.
Do not allow children to hang from
or climb on the projector.
This may cause the projector to fall,
causing injury or death.
Power
Warning
Indoor Installation
Caution
The earth cable should be connected.
Ensure that you connect the earth
cable to prevent possible electric shock.
If it is not possible to ground the unit,
have a qualified electrician install a
separate circuit breaker.
Do not try to ground the projector by
connecting it to telephone wires, light-
ning rods or gas pipes.
The power plug should be inserted
fully into the power outlet.
An unstable connection may cause a
fire.
Do not place heavy objects on
the power cord.
This may create a fire hazard or
cause electric shock.
Do not place the projector close to
sources of steam or oil such as a
humidifier or kitchen counter.
This may create a fire hazard or
cause electric shock.
Do not place the projector
where it might be exposed to
dust.
There is risk of fire.
Do not install the product in a place with
no ventilation (e.g., on a bookshelf or in a
closet) or on a carpet or cushion.
Failure to do so may result in a fire due to
the increase in the internal temperature.
Ensure good ventilation around the
projector. The distance between
the projector and the wall should
be more than 30 cm.
Failure to do so may result in a fire due to
the increase in the internal temperature.
Do not use the projector in a damp
place such as a bathroom where it
is likely to get wet.
This may create a fire hazard or result in
electric shock.
Make sure the air vent is not
blocked by a tablecloth or curtain.
Failure to do so may result in a fire due
to the increase in the internal tempera-
ture.
When placing the projector on a
table or shelf, be careful not to put
it near the edge.
The projector could fall, causing injury,
and damage to the projector. Only use
a suitable stand.
Do not place the projector on an
unstable or vibrating surface such as
a wobbly shelf or a slope.
It may fall and cause injury.
Disconnect the projector from the
power supply and all connected appara-
tus before moving or cleaning.
The power cord may be damaged and
may create a fire hazard or result in elec-
tric shock.
Loading ...
Loading ...
Loading ...