Loading ...
Loading ...
Loading ...
8
CLEANING
IMPORTANT: Disconnect gas and electrical supplies before cleaning any internal surfaces. Malfunctions
caused by excessive lint or dust build up will not be covered under warranty.
Warning: Regular cleaning will not remove the requirement for regular servicing by authorised personnel.
The outer surfaces of the heater should only be cleaned or dusted with a damp cloth. Access to the area in
front of the tiles is achieved by opening the dress guard as follows.
Using both hands, simultaneously apply upward pressure at the bottom left and bottom right of the dress
guard, as indicated in FIG 2, and lift up until the wire rods come out of their locations. Ease the bottom of
the dress guard forward of the front edge of the reflector and pull down as far as it will go (about 2cms).
Pivot the dress guard up until enough space for access is achieved. The dress guard is not removable nor
will it open right up. This has been designed like this for safety reasons.
To close the dress guard to its correct position, pivot it back down, lift it up and guide the ends of the wire
rods back over their location holes then push down firmly to secure the dress guard in place.
Cleaning the area in front of the tiles must be done with great care as the burner tiles are fragile and are
very easily damaged.
Access to the underneath of the heater is gained through the lower louvre panel. This panel is hinged at
the bottom and is opened by gripping the top louvre blade about 3cms in from each end, pushing down
and pulling out (see FIG 2).
This area needs particular attention and should be gently vacuumed out from time to time. The frequency
depends greatly on the environment that the heater is used in, the more furnishings and carpets that are in
close proximity to it, the more frequent the cleaning. A check should be made once every month and
when dust and fluff become apparent, it should be gently vacuumed out. The fan blades may be rotated
by hand whilst vacuuming to ensure all fluff etc, is removed.
DRESS GUARD
The guard is fitted to this appliance to reduce the risk of fire or injury from burns and no part of it should
be permanently removed.
FOR PROTECTION OF CHILDREN OR THE INFIRM, A SECONDARY GUARD IS REQUIRED.
Loading ...
Loading ...