Loading ...
Loading ...
Loading ...
P/N 020661
© 2017 Electrolux Home Products Pty Ltd. ABN 51 004 762 341.
BMAN_CLUB_GASCONV_Oct17
For more information on all BeefEater products, or for
dimension and installation information, call into your retailer,
phone or email our customer care team or visit our website:
AUSTRALIA
phone: 1300 307 939
fax: 1800 356 669
email: customercare@electrolux.com.au
web: beefeaterbbq.com
NEW ZEALAND
phone: 0800 436 245
fax: 0800 225 088
email: customercare@electrolux.co.nz
web: beefeaterbbq.com
GAS LEAK TEST PROCEDURE
Use the following procedure to check for gas leaks.
Never use a naked flame to check for gas leaks.
1. In a small container, mix up a solution of water and
detergent or soap. Mix the solution well.
2. For LPG make sure that the gas supply valve on the gas
cylinder is turned on. For NG make sure that the gas
line is correctly fitted to the appliance.
3. Make sure that the gas control valves on the appliance
are all turned off.
4. Using a brush or spray bottle apply the solution to the
gas line and each join in the gas line.
Using a brush to test for leaks
5. Bubbling of the solution will indicate that there is a leak
present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact your distributor or the
manufacturer for assistance.
Aeration Screw Adjustment
Refer to the specific BBQ manual for any other technical
information required
WARNING
WARNING
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odour continues, immediately call your gas supplier or
your fire department.
WARNING
WARNING
1. Do not store or use gasoline or other flammable vapours
or liquids in the vicinity of this or any other appliance.
2. An LPG cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
SL4000 Side Burner Pilot Injector Replacement:
On the side-burner, remove the valve assembly from the
manifold, disassemble the pilot ignition tube (one screw),
un-screw the pilot jet and replace it with the NG jet (0.95mm)
supplied in your NG kit.
Once done, reassemble the pilot ignition tube to the valve
and then reinstall the valve assembly to the manifold in the
side burner.
Side Burner Pilot Injector Replacement
BBQ AND SIDE BURNER
GAS CONVERSION INSTRUCTIONS