Loading ...
Loading ...
Loading ...
EN 8
ELECTRICAL CONNECTION
WARNING
• Disconnect the appliance from the power supply.
• Installation must be carried out by qualied personnel who know the current safety and installation regulations.
• The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from
failure to observe the regulations provided in this chapter.
• The power cable must be long enough to allow the hob to be removed from the worktop.
• Make sure the voltage specied on the dataplate located on the bottom of the appliance is the same as that of
the home.
Connection to the terminal block
For the electrical connection, use an H05RR-F cable as specied in the table below.
WiresNumber x size
220-240 V ~ +
3 x 4 mm
2
220-240 V 3 ~ +
4 x 1,5 mm
2
380-415 V 3N ~ +
5 x 1,5 mm
2
380-415 V 2N ~ +
4 x 1,5 mm
2
230V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
380-415 V 3N ~
220-240 V ~
(AU and UK)
380-415 V 2N ~
220-240 V ~
380-415 V 2N ~ (Holland only)
220-240 V 3 ~ (Belgium only)
CBA
Important:
• Based on the wiring diagram (see gure) either keep or remove the metal jumpers between the screws on the terminal block L1-L2 and N1-N2.
• If the cable is provided, see the connection instructions attached to the cable.
• Make sure all six screws on the terminal block are tightened after connecting the cables.
Example of jumper present (left) or removed (right). See the wiring diagram for details (the jumpers can be between L1-L2 and between N1-N2).
Connect the yellow/green earth wire to the terminal with the symbol .
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw it on the terminal block with the previously removed screw.
Each time the power is connected, the hob performs an automatic check for a few seconds.
If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power supply by means of a multipole switch
with minimum contact gap of 3mm.
Loading ...
Loading ...
Loading ...