Loading ...
Loading ...
Loading ...
8
Setting the pollution sensors
The appliance is preset to medium sensitivity.
If the air quality indicator remains:
- poor after 2 hours in operation although the air seems to be purified
- excellent for more than 1 hour although the air seems to be polluted
you can adjust the sensor sensitivity as follows:
1. When the air purifier is off, hold down the filtration speed setting button for 2 seconds:
2. Set the sensitivity by briefly pressing the filtration speed setting button:
• Select high sensitivity if the air purifier indicates excellent air quality for more than 1 hour although the air
seems to be polluted.
• Select low sensitivity if the air purifier continues to indicate poor air quality even though it has been operating
for more than 2 hours and the air seems sufficiently purified.
3. The new setting is applied if no button is pressed for 10 seconds.
Start
Briefly press this button to switch the air purifier on or off.
Mode / filtration speed selection
Auto day
Automatic: In this operating mode, the filtration speed automatically adjusts according to the air quality detected
by the particle sensor and the gas sensor. This mode is recommended for general use.
Auto Night
The filtration speed of your appliance is adjusted for a whisper quiet air flow during the night. The light intensity
of the appliance is also reduced. If pollution is detected, the filtration speed increases slightly to purify your air
but remains quiet to avoid disturbing your sleep.
Boost mode
The highest speed level of filtration.
Silent mode
The whisper quiet speed.
Light
You can change the light intensity of the appliance as you wish or according to the time of day.
+ Blue + Purple + Red
Low sensitivity Medium sensitivity High sensitivity
OPERATION
Press Air quality indicator Control panel
1 Light up Light up
2 Moderate light Moderate light
3 Off Moderate light
TE_PURIFICATEUR_PU6075K0_1800143831_01.qxp_1800143831/01 02/06/2017 13:41 Page8
Loading ...
Loading ...
Loading ...