Loading ...
Loading ...
Loading ...
Maintenance and care
64
EJU34400
Lubrication points
To keep moving parts sliding or rotating
smoothly, coat them with water-resistant
grease.
● Throttle cable (carburetor end)
● Choke cable (carburetor end)
● Throttle cable (handlebar end)
Squeeze the throttle lever and remove the
seal. Spray a rust inhibitor into the outer ca-
ble. Refit the seal securely.
● Steering cable ball joint (handlebar end)
● Steering cable inner wire (handlebar end)
(1) To access the steering cable and ball
joint, remove the steering pad by re-
moving the two bolts.
(2) Grease the steering cable ball joints,
both at the handlebar end of the cable
and at the jet thrust nozzle end.
(3) Extend the steering cable inner wire,
and then apply a thin coat of grease to
the inner wire, both at the handlebar
end of the cable and at the jet thrust
nozzle end.
● Steering cable ball joint (jet thrust nozzle
end)
● Steering cable inner wire (jet thrust nozzle
end)
● Handlebar pivot shaft
Lubrication of the handlebar pivot shaft re-
quires disassembly of steering compo-
Recommended water-resistant grease:
Yamaha Marine Grease/Yamaha
Grease A
1 Seal
UF2F10E0.book Page 64 Tuesday, July 31, 2007 1:45 PM
Loading ...
Loading ...
Loading ...