Loading ...
Loading ...
Loading ...
Maintenance and care
61
(4) Loosen the locknut.
(5) Tighten or loosen the adjusting nut until
the desired amount of friction is obtained.
(6) Hold the adjusting nut with one wrench
while tightening the locknut with another
wrench.
(7) Install the handlebar cover and the four
screws.
EJU31282
Adjusting the jet thrust nozzle angle
The angle of the jet thrust nozzle can be ad-
justed to suit operator preference according to
the following procedure.
To change the steering cable pivot bolt posi-
tion:
(1) Remove the two screws, and then re-
move the steering pole cover.
(2) Pull back the outer sleeve of the steering
cable joint, and then disconnect the joint
from the steering cable pivot bolt.
(3) Remove the steering cable pivot bolt.
(4) Select the nozzle angle, install the steer-
ing cable pivot bolt with the lock washer in
the desired position (P1 or P2) on the
Tightening torque:
29.0 Nm (21.4 ft-lb) (2.96 kgf-m)
1 Steering pole cover
1 Steering cable joint
1 Steering cable pivot bolt
2 Steering column
UF2F10E0.book Page 61 Tuesday, July 31, 2007 1:45 PM
Loading ...
Loading ...
Loading ...