Loading ...
Loading ...
Loading ...
94
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
2. Crossover
Change the settings of crossover frequencies.
• As for the THX-certied speakers, the following settings are recommended.
– Crossover frequency → "80Hz(THX)"
– “LPF of LFE” → “80Hz”
– “Double Bass” → “O”
Setting Item Default Value Setting Details
Front 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• If "Conguration" - "Subwoofer" is set to "No",
"Front" is xed to "Full Band", and the low
pitched range of the other channels is output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Center 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
“Conguration” - "Speaker Channels" matches
the number of connected channels.
Height 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
“Conguration” - "Speaker Channels" matches
the number of connected channels.
Setting Item Default Value Setting Details
Surround 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
“Conguration” - "Speaker Channels" matches
the number of connected channels.
Surround Back 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when
"Surround" is set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
“Conguration” - "Speaker Channels" matches
the number of connected channels.
LPF of LFE 120Hz Set the low-pass lter for LFE (low-frequency
eect) signals in order to pass only the lower
frequency signals than the set value, and thus
cancel unwanted noises. The low-pass lter is
eective only on sources with LFE channel.
The value from "80Hz" to "120Hz" can be set.
"O": When this function is not used
Double Bass On This can be selected only when "Conguration”
- "Subwoofer" is set to "Yes" and "Front" is set to
"Full Band".
Bass output is boosted by feeding bass sounds
from the front right and left, and center speakers to
the subwoofer.
"On": Bass output is boosted.
"O": Bass output is not boosted.
• This function is not automatically set even if
AccuEQ Room Calibration is performed.
Loading ...
Loading ...
Loading ...