Loading ...
Loading ...
Loading ...
6
Dryer Dimensions
Location Requirements
You will need:
n A location allowing for proper exhaust installation.
See “Venting Requirements.”
n A separate 30 A circuit for electric dryers.
n A separate 15 or 20 A circuit for gas dryers.
n If you are using power supply cord, a earthed electrical outlet
located within 610 mm (2 ft.) of either side of dryer.
See “Electrical Requirements.”
n A sturdy oor to support dryer and a total weight
(dryer and load) of 90.7 kg. (200 lbs). The combined weight
of a companion appliance should also be considered.
n Level oor with maximum slope of 25 mm (1") under entire
dryer. If slope is greater than 25 mm (1"), install Extended
Dryer Feet Kit, Part Number 279810. If not level, clothes
may not tumble properly and automatic sensor cycles
may not operate correctly.
Do not operate your dryer at temperatures below 7°C (45°F).
At lower temperatures, the dryer might not shut off at the end
of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where
it will be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes,
or sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning appliance can be installed
in the same closet as a dryer.
Installation clearances:
The location must be large enough to allow the dryer door
to open fully.
Do not install behind a lockable door, a sliding door, or a door
with a hinge on the side opposite to that of the dryer in a way
that will restrict the full opening of the dryer door.
Most installations require a minimum 140 mm (5½") clearance
behind the dryer for the exhaust vent with elbow. See “Venting
Requirements.”
A. Wide-opening side-swing door
B. Wide-opening hamper door
NOTE: Leveling legs should be 13 mm (1/2") (to match height
of 0.102 m
3
[3.6 cu. ft.] capacity washer) or 38 mm (1½")
(to match height of 0.108 m
3
[3.8 cu. ft.] capacity washer).
29"
(737 mm)
43
3
/
8
"
(1102 mm)
1
/2"
(13 mm)
29"
(737 mm)
1
1
/2"
(38 mm)
43
3
/8"
(1102 mm)
13 mm
(
1
⁄2")
737 mm
(29")
1102 mm
(43
3
⁄8")
737 mm
(29")
1102 mm
(43
3
⁄8")
38 mm
(1
1
⁄2")
A B
22
3
/4"
(578 mm)
27
3
/4"
(705 mm)
27
3
/4"
(705 mm)
13
3
/4"
(349 mm)
1
/2"
(13 mm)
578 mm
(22
3
⁄4")
705 mm
(27
3
⁄4")
349 mm
(13
3
⁄4")
705 mm
(27
3
⁄4")
13 mm
(
1
⁄2")
Installation Spacing
A. Recessed area
B. Side view—closet or conned area
C. Closet door with vents
*Required spacing
A
B
C
457 mm*
(18")
25 mm
(1")
25 mm
(1")
25 mm
(1")
356 mm*
(14" max.)
705 mm
(27
¾"
)
310 cm
(48 in.
2
)
2
*
76 mm *
(3")
76 mm *
(3")
737 mm
(29")
155 cm
(24 in.
2
)
2
*
A B
C
Loading ...
Loading ...
Loading ...