Loading ...
Loading ...
Loading ...
18
COMPLETE INSTALLATION
CHECKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Check dryer’s nal location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See “Level Dryer.”
q
Remove lm on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
q
Read “Dryer Use” in your Use and Care Guide.
q
Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
n Dryer is plugged into an earthed 3-prong outlet.
n Electrical supply is connected.
n Household fuse is intact and tight or circuit breaker has
not tripped.
n Dryer door is closed.
q
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle
and close the door.
If you do not feel heat, turn the dryer off and check to see
whether gas supply line shut-off valve is open.
n If the gas supply line shut-off valve is closed, open it,
then repeat the 5-minute test as outlined above.
n If the gas supply line shut-off valve is open, contact
a qualied technician.
NOTE: You may notice an odor when the dryer is rst heated.
This odor is common when the heating element is rst used.
The odor will go away.
Select the plug that ts with the electric receptacle.
NOTE: Plug types and quantities will vary by model.
1. Select plug
POWER CORD INSTALLATION
(on some models)
Assemble the plug into the end of the power cord located on
the back of the dryer.
2. Assemble plug
Secure the power cord by seating the connection on the cord
lock. Place the cord lock cover and push until it snaps. Make
sure the power cord connection is seated on the cord lock
and that the cord lock clamps correctly.
Plug power supply cord into an earthed outlet. Turn power
supply on.
3. Secure power cord
IMPORTANT: To be performed by Whilrpool Corporation
authorised service personnel only.
Loading ...
Loading ...
Loading ...