Loading ...
Loading ...
Loading ...
15
To remove the base
grille, open the doors
and then pull the
grille straight out.
5/16″ Socket
Wrench
Raise
The rollers have 3 purposes:
Rollers adjust so the door closes easily when opened
about halfway.
Rollers adjust so the refrigerator is firmly positioned
on the floor and does not wobble.
Rollers allow you to move the refrigerator away from
the wall for cleaning.
To adjust the rollers, remove the base grille by pulling it
out at the bottom.
Turn the roller adjusting screws clockwise to raise the
refrigerator, counterclockwise to lower it. Use an
adjustable wrench (3/8″ hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between the bar and the bottom of the cabinet. Push
forward until grille snaps into place.
ROLLERS DOOR ALIGNMENT
After leveling, make sure that doors are even at the top.
To make the doors even, adjust the refrigerator
compartment door. Using a 5/16″ socket wrench, turn the
door adjusting screw to the right to raise the door, to the
left to lower it. (A nylon plug, embedded in the threads of
the pin, prevents the pin from turning unless a wrench is
used.) After one or two turns of the wrench, open and
close the refrigerator compartment door and check the
alignment at the top of the doors.
Installation Instructions
Loading ...
Loading ...
Loading ...