Loading ...
Loading ...
Loading ...
A37564,R22GV,/22GT/23GT/24GT/25JT
4
START
0
0
Please check the following before calling for service!
1. Plug the power cord into a three-pronged electric-outlet. (See page 5)
2. Place one cup of water in a glass measure in the oven and close the door securely.
_______oN_______seY?no emoc thgil nevo eht seoD.A
_______oN_______seY?krow naf gnilooc eht seoD.B
(Put your hand over the back ventilating opening.)
C. If "No", please check wall outlet and circuit breaker.
3. Touch these pads:
_______oN_______seY?no emoc rotacidni "NO" eht seoD.A
_______oN_______seY?toh retaw eht si ,etunim 1 fo dne eht tA.B
IF SERVICE IS NEEDED, PLEASE CONTACT YOUR NEAREST AUTHORIZED SHARP SERVICER.
1
SELECTATIME
deriuqeR noitcAnosaeRedoM EE
EE 1, EE 2 Magnetron failure Call for service.
EE 3 Both magnetrons failed Call for service.
EE 4 Voltage too high Follow instructions on page 5 of Operation
egnahc ot TCELES EGATLOV rednu launaMR-25JTF only
,detcerroc ton si melborp fI .V032 ot V802 morf
call an electrician.
EE 5 Voltage too low Follow instructions on page 5 of Operation
egnahc ot TCELES EGATLOV rednu launaMR-25JTF only
,detcerroc ton si melborp fI .V802 ot V032 morf
call an electrician.
EE 6, EE10, EE16
Thermistors failure Call for service.
EE 7 Exhaust air temperature too high Check that nothing is blocking air intake open-
ings on oven back or that oven exterior is very
hot. Correct. Wait a few minutes and try again.
If problem persists, call for service.
.ecivres rof llaCeruliaf tiucriC8 EE
EE 9 Maximum time is exceeded Check page 11 in the Operation Manual.
Touch STOP/CLEAR pad, and reprogram cor-
rectly.
.ecivres rof llaCrorre kcol naF0 EE
EE17 Magnetron temperature
too high Touch STOP/CLEAR pad. Wait a few minutes
and try again. If problem persists, call for ser-
vice.
SERVICE CALL CHECK
ERROR MODE
Should any of the error indicators appear in the readout, follow the instructions:
EE 1 and EE 2: Can continue to use oven before service; however, check food carefully as additional
cooking time will be needed.
Anytime the EE is flashing, the servicer should be called. When EE is not flashing, check the reason and correct.
Service is not necessary.
Loading ...
Loading ...
Loading ...