Loading ...
Loading ...
3
ENGLISH
LOCK SETUP
Follow these steps to get your lock set up and ready to use. If you would like to use a home
automation system to enable remote control of the lock, refer to Enrolling on a Z-Wave
Network on page 13.
1 Decide what length you want the User Codes for the lock to be.
You can set User Codes to be from 4 - 8 digits in length. The default length is 4 digits. All User
Codes must be the same length. Any time you change the User Code length, all current User
Codes will be deleted from the lock.
• See Change User Code Length on page 7.
2 Add/Delete User Codes.
The lock comes preset with two unique User Codes. You can either use these codes or
remove them and program your own codes.
• See Add User Code and Delete User Code on page 7.
3 Decide if you want to use the Auto-Lock feature or not.
When the Auto-Lock feature is enabled, the lock will automatically relock itself 30 seconds
after being unlocked.
• See Enable/Disable Auto-Lock on page 7.
4 Turn on the alarm and decide which mode you want to use.
The alarm is turned off by default. If you want to use the alarm, you’ll need to turn it on and
decide on a mode.
• See Programming the Alarm on page 8.
PLEASE KEEP THIS GUIDE
This guide contains important information about your lock!
• Default User Codes and Programming Code are located on the sticker on the back of
this guide! You will need these if you ever need to reset your lock back to factory default
settings!
• The sticker also contains your serial number, which may be needed for warranty and
customer service support.
• Instructions for adding and deleting User Codes, changing the lock behavior,
troubleshooting, customer service and more are explained in this guide!
WARRANTY AND FCC/IC STATEMENTS
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure
To comply with FCC/IC RF exposure requirements for
mobile transmitting devices, this transmitter should only be
used or installed at locations where there is at least 20 cm
separation distance between the antenna and all persons.
Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
This Device complies with Industry Canada License-exempt
RSS standard(s). Operation is subject to the following
two conditions: 1) this device may not cause interference,
and 2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Loading ...
Loading ...
Loading ...