Loading ...
Loading ...
Loading ...
15
www.napoleongrills.com
N415-0271-AU JAN 24.18
Troubleshoong
Problem Possible Causes Soluon
Low heat / Low ame
when valve turned to
high.
For Universal Liqueed
Petroleum Gas - improper
lighng procedure.
For natural gas -
undersized supply line.
For both gases - improper
preheang.
Ensure lighng procedure is followed carefully.
All gas grill valves must be in the o posion
when the tank valve is turned on. Turn tank on
slowly to allow pressure to equalize. See lighng
instrucons.
Pipe must be sized according to installaon code.
Preheat grill with both main burners on high for 10
to 15 minutes.
Excessive are-ups/
uneven heat.
Sear plates installed
incorrectly.
Improper preheang.
Excessive grease and ash
build on sear plates and in
drip pan.
Ensure sear plates are installed with the holes
towards the front and the slots on the boom. See
assembly instrucons.
Preheat grill with both main burners on high for 10
to 15 minutes.
Clean sear plates and drip pan regularly. Do not
line pan with aluminum foil. Refer to cleaning
instrucons.
Burners burn with
yellow ame,
accompanied by the
smell of gas.
Possible spider web or
other debris, or improper
air shuer adjustment.
Thoroughly clean burner by removing. See general
maintenance instrucons. Open air shuer
slightly according to combuson air adjustment
instrucons. (This must be done by a qualied gas
installer.)
Flames li away from
burner, accompanied
by the smell of
gas, and possibly
dicules in lighng.
Improper air shuer
adjustment.
Close air shuer slightly according to combuson
air adjustment instrucons. (This must be done by
a qualied gas installer.)
Rear and Side burners
will not light with the
igniter, but will light
with a match.
Dead baery / or installed
incorrectly.
Loose electrode wire or
switch terminal wires.
Liing ames on burner.
Replace with premium heavy duty baery.
Check that electrode wire is rmly pushed onto
the terminal on the back of the igniter. Check that
the lead wires from the module to the ignion
switch (if equipped) are rmly pushed onto their
respecve terminals.
Close air shuer slightly - see previous problem.
Main burner will not
light with the igniter,
but will light with a
match.
Jet-re outlet is dirty or
clogged.
Clean jet-re outlet with a so bristle brush.
Humming regulator. Normal occurrence on hot
days.
This is not a defect. It is caused by internal
vibraons in the regulator and does not aect the
performance or safety of the gas grill. Humming
regulators will not be replaced.
Loading ...
Loading ...
Loading ...