Loading ...
Loading ...
Loading ...
13
Complete the Installation
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See “Prepare the Water System” or “Water
and Ice Dispensers.”
NOTE: Allow 24 hours to produce the first batch of ice. Allow 72 hours to
completely fill ice container.
Prepare the Water System
Please read before using the water system.
Immediately after installation, follow the steps below to make sure that the
water system is properly cleaned.
1. Open the freezer door and turn off the ice maker. The On/Off switch
can only be accessed when the ice storage bin has been removed. The
switch is located on the freezer door, on the left side of the wall that
surrounds the ice storage bin. Move the switch to the OFF (right)
setting.
2. Make sure the water filter is properly installed.
3. Flush the water system. Use a sturdy container to depress and hold
the water dispenser lever for 5 seconds, then release it for 5 seconds.
Repeat until water begins to flow. Once water begins to flow,
continue depressing and releasing the dispenser lever (5 seconds on,
5 seconds off) until a total of 3 gal. (12 L) has been dispensed. This
will flush air from the filter and water dispensing system, and prepare
the water filter for use. Additional flushing may be required in some
households. As air is cleared from the system, water may spurt out of
the dispenser.
4. Open the freezer door and turn on the ice maker. Move the switch to
the ON (left) position. Please refer to the “Ice Maker and Storage
Bin” section for further instructions on the operation of your ice maker.
■ Allow 24 hours to produce the first batch of ice.
■ Discard the first three batches of ice produced.
■ Depending on your model, you may want to select the maximum
ice feature to increase the production of ice.
Install CleanFlow™ Air Filters
(on some models)
On some models, your refrigerator's accessory packet includes two air
filters, which must be installed prior to use. On some models, the air filters
are already installed at the factory.
The air filter reduces the buildup of odors. This helps to maintain a cleaner
environment inside the refrigerator.
Installing the Air Filters (on some models)
The filters should be installed in two separate locations.
Location 1:
Install one of the filters behind the vented door, which is located
(depending on your model) along either the rear or left interior wall
near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
4. Close the vented door.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Loading ...
Loading ...
Loading ...