Loading ...
Loading ...
Loading ...
UNDER-BENCH INSTALLATION INSTRUCTIONS
INSTALLATION
require 10mm clearance on both sides and 30mm on top,
30mm clearance at the rear (Back spacer is provided), to
facilitate installaon, removal, servicing and venlaon.
as other appliances such as ovens or an area that is sealed
and without access to fresh cool air. Failing to comply
with the above specificaons could result in WARRANTY
void.
Cross secon
Dimensional drawings:
30mm30mm
10
30
31
30
30
555
525
30
10
10
850
820
615
595
10
Side View
Front View
Top View
30
31
30
555
525
Side View
10
30
555
525
10
5
User Manual
Front View (VWS050SBA-X/VWS050SSA-X/
VWD050SBA-X/VWD050SSA-X/VBS050SBA-X/
VBS050SSA-X
DIMENSIONS:
VWS050SBA-X/VWS050SSA-X/VWD050SBA-X/
VWD050SSA-X/VBS050SBAX/VBS050SSA-X
Height 820mm – 860mm (40mm adjustable feet)
Width 595mm
Depth 571mm + 30mm stopper (Total of 601mm)
This Vintec Wine Cellar and Beverage Centre is not
designed to be fully integrated behind a joinery door.
Please note that:
For VWS050SBA-X/VWS050SSA-X/VWD050SBA-X/
VWD050SSA-X/VBS050SBA-X/VBS050SSA-X
a minimum cut out width of 615mm is required to
facilitate installaon, removal and servicing.
1. Vintec “Built in” Wine Cellar and Beverage Centres
are front venng but are not designed to be fully
integrated behind a joinery door.
INSTALLATION DRAWINGS FOR fornt venng under
bench Wine Cellars and Beverage Centres:
3. Vintec Built in Wine Cellar and Beverage Centres
draw air from the rear and expels it through the metal
grid under the door at the front. If a kick board is to be
placed in front of the Wine Cellar and Beverage Centre’s
grid another one must be fied into the kick board with
a minimum air flow allowance of 150cm².
4. Vintec “Built in” Wine Cellar and Beverage Centres have
a power switch located on the control panel so power
point locaon is not crical.
5. The Wine Cellar and Beverage Centre requires a
standard 240 volt/10 amp power point. (Or according
to different countries specificaons).
6. The power cord is 1.9m in length and is fixed on the
right side at the back when looking from front of cabinet.
7. As with most appliances of today, the Wine Cellar and
Beverage Centre has sensive electronic components
which are suscepble to damage through lightning and
electricity supply faults. It is therefore advised to use a
power surge protector to avoid problems of this nature.
8. Air vent within the joinery must be provided for Vintec
built in Wine Cellar and Beverage Centres (Front venng)
In Hot climate zone, an air vent or grid, with a minimum
venlaon size of 200mm x 40mm MUST be cut out at
the rear top of the back paroning or at the top of either
side of the paroning, allowing cool fresh air full access
to flow into the 30mm gap located at the rear of the
cabinet.
This air vent or grid must not be opened on the same side
Top View
2. Vintec “Built in” Wine Cellar and Beverage Centres
Loading ...
Loading ...
Loading ...