Loading ...
Loading ...
Loading ...
13
7. Remove the hinge plate located behind the roller bracket and
move it to the opposite side of the refrigerator. Move the hinge
pin and shim to the outside hole on the hinge plate as shown
below.
A. Hinge Pin Shim D. Roller Bracket
B. Bottom Hinge E. 3/8" Hex-Head Hinge Screws
C. Hinge Plate
Replace Doors and Hinges
NOTE: Graphic may be reversed if door swing is reversed.
Standard Door - Freezer drawer models
1. Replace the parts for the bottom hinge as shown below.
Tighten screws.
A. Hinge Pin Cover C. Hinge Screws
B. Bottom Hinge
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door gasket
magnets to hold the door in place while you are working.
2. Assemble the parts for the top hinge as shown below. Do not
tighten screws completely.
A. Hinge Cover Screw C. 5/16" Hex-Head Hinge Screws
B. Top Hinge Cover D. Top Hinge
3. Adjust the door so that the bottom of the refrigerator door is
aligned with the top of the freezer drawer. Tighten all screws.
Standard Door - Freezer door models
1. Make sure the hinge plate is securely fastened behind the
roller bracket and that the hinge pin is inserted into the outside
hole. Fully tighten all roller bracket screws.
A. Hinge Pin Shim D. Roller Bracket
B. Bottom Hinge E. 3/8" Hex-Head Hinge Screws
C. Hinge Plate
2. Remove the shim that you placed under the front edge of the
refrigerator cabinet. Replace the freezer door
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door gasket
magnets to hold the door in place while you are working.
3. Assemble the parts for the center hinge as shown below, and
tighten all the screws. Replace the refrigerator door.
A. Hinge Pin Cover C. Hinge Screws
B. Center Hinge
4. Assemble the parts for the top hinge as shown below. Do not
tighten the screws completely.
5. Adjust the doors so that the bottom of the refrigerator door is
aligned with the top of the freezer door. Tighten all screws.
Loading ...
Loading ...
Loading ...