Loading ...
Loading ...
Loading ...
— 15 —
English
CHANGING THE EXHAUST
DIRECTION
The direction of the exhaust vent can be changed by
turning the top cover.
CUTTING OFF THE SHEET
Tear off the output sheet in the direction of the arrow
when using the sheet collated nails.
USING THE NOSE CAP
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
1 DISCONNECT AIR HOSE FROM NAILER.
2 Put the nose cap to the toe of the push lever.
NOTE:
䢇 The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
䢇 After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic tool
lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held firmly against the workpiece.
adjust the nailing depth in the following order.
If nails are driven too deep or shallow into the workpiece,
1 DISCONNECT AIR HOSE FROM NAILER
2 If nails are driven too deep, turn the adjuster to the
shallow side.
If nails are driven too shallow, turn the adjuster to the
deep side.
3 Stop turning the adjuster when a suitable position is
reached for a nailing test.
4 Connect the air hose.
ALWAYS WEAR EYE PROTECTOR.
Perform a nailing test.
5 DISCONNECT AIR HOSE FROM NAILER.
6 Choose a suitable position for the adjuster.
Adjuster
( )
( )
Too shallow
Too deepFlush
Deep
Shallow
Top Cover
Exhaust
Vent
Nose Cap
Do not connect
air hose
1
Push Lever
Hole
Nose
Protrusion (Inward)
Sheet
Loading ...
Loading ...
Loading ...