Loading ...
Loading ...
Loading ...
— 13 —
English
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Slide in vertical direction possible.
Lift or lower the nail holder to accept different
length nails.
3 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 90
degrees clockwise until you hear "click".
(3) Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Wire collated nails
Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
Fit the nail head in the guide slot.
Plastic sheet collated nails
Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
Fit the nail head and upper side of the plastic sheet in
the guide slot.
Fit the lower side of the plastic sheet in the guide slot
for plastic sheets.
(5) Close the magazine cover first and swing the nail
guide closed.
(6) Lock the knob correctly.
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
Magazine
Nail holder
Pawl 1
Pawl 2
Guide slot for plastic sheet
Driving hole
First nail
Guide slot
Magazine cover
Knob
Nail guide
Nail holder
Magazine
1
3
/4
2 2
1
/4
2
3
/8 2
1
/2 3
3
1
2
Magazine
Magazine cover
Nail holder
First nail
Nails
Guide slot
First nail
Pawl 1
Pawl 2
Driving hole
Magazine
cover
Loading ...
Loading ...
Loading ...