Loading ...
Loading ...
Loading ...
GDW45S 45cm Freestanding Dishwasher User Manual Page 6
Compartment A:
For each wash cycle.
Compartment B:?
For programs with pre-wash only.
(Follow the user instructions)
Compartment C:
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Select a program
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent
dispenser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid
scald,as the dishes and utensils are still hot and more susceptible to break.
They could also dry better. Unload the appliance, starting from the lower basket.
Changing the program
Add forgotten dishes in
the dishwash
er.
Scrape off any large food particles. Soften remnants of burnt food in
pans, then load the baskets. Refer to the dishwasher loading instructions.
When the working cycle is finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appiance was under standby mode, it will be power off automaticly after 30 minutes without
any Operation.
If the appliance is
switched off during a
wash cycle.
Open the door carefully.
Hot steam may escape
when the door is opened!
WARNING!
If the appliance is switched off during a wash cycle, when switched on again, please
re-select the washing cycle and operate the dishwasher according to the original
Power-on state ).
Switch on the appliance
Quick Operation Guide
For detailed operating method read the corresponding content on the instruction manual.
Open the door, press the On/Off button to switch on the appliance.
T urn on the water tap and press the Start/Pause Button. The machine will start working
after about 10 seconds.
Close the door,press the Program Button until the selected program lights
up.( See the section entitled Operation instruction )
1. A running cycle can only be modified if it has been running for a short time. Otherwise the
detergent may have already been released and the water already drained. If in this case, the
detergent dispenser must be refilled.
2. Press the Start/Pause button, the machine will be in standby state, press the program
button more than 3 seconds then you can change the program to the desired cycle setting.
3. Press the Start/Pause Button, the dishwasher will run after 10 seconds.
1.Press the Start/Pause Button to stop the washing.
2.Open the door a little.
3.After the spray arms stop working, you can open the door
completely.
4.Add forgotten dishes.
5.Close the door.
6.Press the Start/Pause Button, the dishwasher will run after 10
seconds.
A
B
C
Loading ...
Loading ...
Loading ...