Loading ...
Loading ...
Loading ...
12
IMPORTANT
After connecting the water supply, refer to
“How to Prime the Water Supply System”
for important information about priming an
empty water supply system.
To ensure that your water dispenser works
properly, the water supply system must be
completelylledwithwaterwhenyourre-
frigeratorisrstconnectedtothehousehold
water supply line.
Figure 2
Figure 1
Plastic Water
Tubing to Ice
Maker Fill
Tube
Steel
Clamp
Brass
Compression
Nut
Ferrule
(Sleeve)
Copper
water line
Water Valve
Bracket
Valve Inlet
Water Valve
Copper water line
from household
water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
CONNECTING THE WATER SUPPLY
5 With steel clamp and screw, secure water
supply line (copper tubing only) to rear
panel of refrigerator as shown.
6 Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange coils so
they do not vibrate or wear against any
other surface.
7 TurnONwatersupplyatshutovalveand
tighten any connections that leak.
8 Reconnect refrigerator to electrical power
source.
9 To turn ice maker on, lower wire signal
arm (side mounted) or set the ice maker’s
On/Opowerswitchtothe“I”position
(rear mounted).
Steel
Clamp
Water Line
Water Valve
Bracket
Valve Inlet
Water Valve
Water line
from household water supply
Plastic Water Tubing
to Ice Maker
Fill Tube
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Loading ...
Loading ...
Loading ...