Loading ...
Loading ...
Loading ...
When moving your refrigerator
To prevent floor damage, be sure the
front adjusting legs are in the up position
(above the floor).
Refer to ‘Leveling the Refrigerator’ in the
manual (on page 22).
Flat-blade screw
driver (-)
Control Lever
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support
a fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull
and push it straight forwards or back.
Do not wiggle it from side to side.
CAUTION
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location.
Do not remove the doors/drawer if you don’t
need to.
If you need to remove the doors. continue below.
If you do not need to remove the refrigerator
doors, go to `Leveling the Refrigerator’ on page
22.
Disconnect power to the refrigerator
before removing the door or drawer.
• Be careful not to drop, damage, or
scratch the doors/drawers while
removing them.
• Use care when you remove the doors/drawers.
The doors are heavy and you could injure
yourself.
• Reattach the doors/drawers properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the
doors while removing them.
WARNING
WARNING
English - 18
DA68-03022B (EN)-08.indd 18 2016. 3. 24. �� 3:06
Loading ...
Loading ...
Loading ...