Loading ...
Loading ...
Loading ...
11
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call...
http://www.amana.com/help
If you experience
Possible Causes
Solution
TROUBLESHOOTING
Make sure all four ll hose at washers are properly seated.
Drain hose connection.
Pull drain hose from washer cabinet and properly secure it to drainpipe
or laundry tub.
Do not place tape over drain opening.
Check household plumbing
for leaks or clogged sink or drain.
Water can back up out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water pipes,
and faucets.)
Fill hose washers.
Improper loading can cause basket to be out of alignment and
cause water to splash off tub. See “Using Your Washer” for loading
instructions.
Washer not loaded as
recommended.
Water Leaks (cont.)
Washer not performing as expected
Washer won’t run
or ll, washer stops
working or wash light
remains on (indicating
that the washer was
unable to ll
appropriately)
Check for proper water supply.
Both hoses must be attached and have water owing to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water ow.
If you experience
Possible Causes
Solution
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Check proper electrical supply.
Washer not performing as expected (cont.)
Washer won’t run
or ll, washer stops
working or wash light
remains on (indicating
that the washer
was unable to ll
appropriately) (cont.)
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not interrupt
cycle.
Washer spins the dry load for several minutes before lling to determine
if load is balanced. You may hear the hum of the spins. This is normal.
Check the following
for proper installation:
(cont.)
Washer may be tightly
packed.
Remove several items, rearrange load evenly in basket, and add
detergent. Close lid and press START/PAUSE/UNLOCK.
Do not add more than 1 or 2 additional garments after cycle has started
to avoid tightly packing or unbalancing.
Loading ...
Loading ...
Loading ...