Loading ...
Loading ...
Loading ...
7
7" (17.8 cm) round vertical vent system 3¹⁄₄" x 10" (8.3 x 25.4 cm) horizontal vent system
Prepare Range Hood
1. Set the range hood on a surface such as cardboard or a large
towel. Remove the 7" (17.8 cm) round vent plate from top of
hood. Set vent plate and mounting screws aside.
2. Remove tape holding standard filters in place. Remove both
filters. Insert flat blade screwdriver into slots in filters. Push
each filter toward back of range hood, lift out and set aside.
3. Remove damper/vent connector from inside the hood. Set
aside connector, mounting screws and bag containing parts.
4. Remove wiring cover from inside the hood. Set aside cover
and mounting screws.
5. Depending on your installation, remove either top or back
wiring knockout and install a ¹⁄₂" UL or CSA listed strain relief.
For non-vented installations
Go to “Make Electrical Connection” section.
For vented installations
1. Remove the five screws holding the light panel in place and
set them aside.
2. Disconnect the light assembly wiring connector. Make sure
not to disconnect any wires.
3. Remove the light panel and set aside.
5"
(12.7 cm)
centerline
wall
7¹⁄₂"
(19.1 cm)
2"
(5.1 cm)
1¹⁄₄" (3.2 cm)
dia. hole
8" (20.3 cm)
dia. hole
¹⁄₈"
(3.2 mm)
3³⁄₄"
(9.5 cm)
centerline
cabinet front
5¹⁄₄"
(13.3 cm)
7¹⁄₂" (19.1 cm)
³⁄₄"
(19 mm)
1¹⁄₄" (3.2 cm)
dia. hole
A. Filter slots
B. Flat blade screwdriver
A. Damper/vent connector
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
B
A
A. Wiring cover
A. Strain relief
A. Light panel
A
A
A
Loading ...
Loading ...
Loading ...