User Manual AEG KKK994500M Integrated Coffee Machine

• Owner's manual - (English)

• Specification Sheet - (English)

Automatic Built-In Coffee Machine USER MANUAL AEG KKK994500M

CONTENTS

• SAFETY INFORMATION
• SAFETY INSTRUCTIONS
• PRODUCT DESCRIPTION
• CONTROL PANEL
• BEFORE FIRST USE
• DAILY USE
• MAKING COFFEE
• MAKING CAPPUCCINO AND MILK-BASED COFFEES
• FAVOURITE
• CLEANING
• DESCALING
• SETTING WATER HARDNESS
• WATER SOFTENER FILTER
• TECHNICAL DATA
• DISPLAYED MESSAGES
• TROUBLESHOOTING

Using the milk container

1. Remove the lid (fig. 16 Quick Guide);
2. Fill the milk container (B8) with a sufficient quantity of milk, not exceeding the MAX level marked on the container. Each mark on the side of the container corresponds to about 100 ml of milk;
3. Make sure the milk intake tube is correctly inserted in the bottom of the milk container lid (fig. 16 Quick Guide);
4. Place the lid back on the milk container;
5. Remove the hot water/steam spout (B6);
6. Attach the milk container (B8) to the connection nozzle (A5) and push as far as it will go (fig. 17 Quick Guide).
7. Place a sufficiently large cup under the coffee spouts (A7) and frothed milk spout. Adjust the length of the milk spout. To move it nearer the cup, simply pull it downwards (fig. 18 Quick Guide).
8. Follow the instructions below for each function.

Turn the froth adjustment dial on the milk container lid to adjust the amount of froth on the milk delivered while making milk-based coffees.

Cleaning the hot water/ steam spout after use

Always clean the hot water/steam spout (B6) after use to avoid the build-up of milk residues and prevent it from clogging.

1. Place a container under the hot water/steam spout and deliver a little water. Stop delivery of hot water by pressing STOP.
2. Wait a few minutes for the hot water/ steam spout to cool down, then extract. Hold the spout with one hand and with the other, turn the cappuccino maker and pull it downwards.
3. Also remove the steam connection nozzle by pulling it downwards.
4. Check the hole in the connection nozzle is not blocked. If necessary, clean using a toothpick.
5. Wash all parts of the spout thoroughly with a sponge and warm water.
6. Insert the connection nozzle, then the cappuccino maker on the spout by pushing it upwards and turning it clockwise until it is attached.