Loading ...
Loading ...
Loading ...
14 15
De-Scaling –
Mineral content in water varies from place to place. Depending on the mineral
content of the water in your area, calcium deposits or scale may build up in your Brewer. Scale
is non-toxic, but left unattended, it can hinder Brewer performance. De-scaling your Brewer
helps maintain the heating element and other internal parts of the Brewer that come in contact
with water. See De-Scaling in page 16 for more information.
Storing – When storing your Brewer, carefully empty the Drip Tray and make sure
the Water Reservoir is empty. Store your Brewer upright in a safe, dry, frost-free
environment.
CLEANING AND MAINTAINING YOUR SINGLE SERVE
BREWER
Cleaning External Parts
CAUTION: Make sure the Brewer is unplugged before cleaning.
Regular cleaning of the Brewer’s external components is recommended.
1. The Housing and other external components may be cleaned with a soapy, damp,
non-abrasive cloth.
CAUTION: Never immerse the Brewer in water or other
liquids.
2. The Drip Tray can accumulate liquids. The Drip Tray and Drip
Tray Plate should be periodically inspected and cleaned with
a damp soapy nonabrasive lint free cloth. The Drip Tray and
Drip Tray Plate should not be put into the dishwasher. To
remove the Drip Tray Assembly, simply slide it toward you,
keeping it level at all times to avoid spilling.
Cleaning the K-Cup
®
Pack Holder
Assembly
1. Cleaning the Parts – The K-Cup
®
Pack Holder Assembly
can be placed onto the top shelf of a dishwasher.
NOTE:
Use low temperature cycles in the dishwasher. To remove
from the Brewer, pull forward the front face of the Brewer.
FIGURE 1
!
Grasp the top of the K-Cup
®
Pack Holder with one hand while pushing up on
the bottom of the K-Cup
®
Pack Holder from underneath with the other until it
releases. After cleaning, align the K-Cup
®
Pack Holder with the opening using
the two front ribs as a guide, and snap into place from the top.
2. Cleaning the Funnel – The Funnel can be removed from the K-Cup
®
Pack
Holder by pulling on it until it snaps off (fig. 1). The Funnel is dishwasher safe. To
replace it, just snap it back onto the K-Cup
®
Pack Holder Assembly.
3. Cleaning the Exit Needle – The Exit Needle is located on the inside bottom of
the K-Cup
®
Pack Holder Assembly. Should a clog arise due to coffee grinds,
it can be cleaned using a clean household tool. Remove K-Cup
®
Pack Holder
assembly and detach Funnel. Insert the household tool into the Needle to loosen
the clog and push it out. The K-Cup
®
Pack Holder is dishwasher safe.
CAUTION: There are sharp needles that puncture the K-Cup
®
Pack above the
K-Cup
®
Pack Holder and at the bottom of the K-Cup
®
Pack Holder. To
avoid risk of injury, do not put your fingers in the K-Cup
®
Pack Assembly
Housing.
NOTE: Over time, discoloration, spotting or staining may appear in the Water
Reservoir. This is normal and will vary depending on the mineral content
of the bottled or filtered water used in the Brewer and will not affect the
operation of the Brewer.
Cleaning the Water Reservoir
Discard the remaining water by removing the water reservoir from the brewer, then
by removing the lid and turning the water reservoir upside down over the sink. The
water reservoir and lid are top rack dishwasher safe. They should be cleaned with
a damp, soapy, non-abrasive cloth and rinsed thoroughly.
NOTE: Do not dry the inside of the water reservoir with a cloth as lint may remain.
BVMC-SC500 Series_16ESM1.indd 14-15 5/5/16 10:44
Loading ...
Loading ...
Loading ...