Loading ...
Loading ...
Loading ...
C ecure the hose as shown
in Figures 3 Standpipe, 4
® Tub, 5 In wall standpipe.
FigUreCable5Tie _ ..........
BE SURE THE HOSE IS NOT
TWISTED OR KINKED AND IS
SECURELY IN PLACE.
Alternate Exhaust
Methods
There are exhaust kits
a available that allow you to
o direct filtered exhaust
air inside to conserve energy during
winter months. You may use these
deviceswith the Laundry Center dryer
providing their use does not violate
national or localcodes, and the device
does not restrictexhaust airflow. Ifyou
use one of these kits, be aware that
excessive moisture in the home can
causemany problemsand that you may
seean increase in the time required to
drya load.Also, you must maintain the
kit installation properly to avoid
excessivelint buildup, which can affect
the dryer's performance.
For mobile home installa-
B tion, the dryermust havean
o outside exhaust. If you
exhaustthe dryerthrough the floor and
the area under your mobile home is
enclosed, the exhaust system must
terminate outside the enclosed area.
Extension beyond the enclosure will
prevent lint and moisture buildup under
the mobile home. See Figure 7.
Mobile home installation
i!
Figure7
Alternate electrical
connection
Disconnect power supply cord from
electric supply before making these
changes.
Electrical ground is required on this
appliance.
This appliance is manufactured with the
neutral terminal connected to the frame.
A If local codes permit the use
of a flexible-type power
® supply cord (pigtail) and:
DO NOT permit connection of the
frame grounding conductor to the
neutral wire of the power supply
cord:
a. Remove terminal block cover.
b. Remove the ground wire from the
green ground screw and f_sten
under center silver-colored
terminal block screw. See Figure
8.
_-_€'I _ Ground clamp
"'"_)_T'_ attach to metal
cold water pipe
Ground wire _ ] Green
#10 mirfimurn f l jground
(not supplied)_[[
gmund_'_ \q V/ colored
wire ] ]![ screw
Ungrounded neutral
Figure 8
Connect separate copper ground wire
from green ground screw to approved
ground.
Connect a separate copper
ground wire (No. 10 minimum)
to a grounded cold water pipe*
by means of a clamp and then to
the frame of the appliance at the
green ground screw. Use Part
No. 685463 ground wire and
clamp assembly. Do not ground
to a gas supply pipe. Do not
connect the power supply cord
to electric power supply until
appliance is permanently
grounded.
d. Replace terminal block cover.
Page 6
Figure 9 Clam
Metal
Pipe
No. 4 Copper Wire
*Grounded cold water pipe must have
metal continuity to electrical ground and
not be interrupted by plastic, rubber or
other electrical insulating connectors
(such as hoses, fittings, washers or
gaskets, including water meter or pump).
Any electrical insulating connector
should be jumped as shown in Figure 9
with a length of No. 4 wire securely
clamped to barn metal at both ends.
B Local codes DO NOT permit
the use of a power supply
® cord and:
1. Permit connection of the frame
grounding conductor to the neutral
wire of the power supply cord:
a. Remove the terminal block
cover.
Terminal
Block --.
Figure 10
b. Install U.L. approved strain relief
(Figure 11) in one inch hole on
duet back below terminal block
opening.
Figure 11
c. Install copper power supply
cable.
Loading ...
Loading ...
Loading ...