Loading ...
Loading ...
Re-key the lock to work with your existing key. See the
supplied SmartKey Re-key instructions for more information.
Note: If Auto-Lock is enabled (see “Switches and Status LED
Colors”), remove the battery pack before re-keying your lock.
Optional: Re-key deadbolt (if needed)
8
K
3 / 4
Add the lock to your smart home system
Initiate the process to add the
lock to your system at your
smart home controller.
Refer to your smart home
system instructions for
more information.
When prompted by your smart home system to add the
lock, press button “A” on the lock interior one time. The
red LED will illuminate when the lock enters Add Mode.
If successful, re-name the lock in your system (if applicable).
If unsuccessful, follow your system's instructions to remove
the lock from the controller and any other network, then press
button “A” on the lock one time.
Perform steps 6A6C again.
If still unsuccessful, consult the Programming and
Troubleshooting Guide, available on the “Deadbolt with
Home Connect” page at kwikset.com/wirelesslocks.
A B C
D
Please allow time for the controller to add the lock.
button “A”
actual
size
X (x3)
F
F
The window
on the interior
cover is locked
by default to
prevent someone
from tampering
with your lock's
settings.
Important Information about the interior cover
Cover Installation Battery Pack Access
Install cover.
Note: You may
need to rotate
the turnpiece to
align with the
turnpiece shaft.
turnpiece
turnpiece
shaft
Install
screws.
a
b
If the window is unlocked,
slide up the window to
access the battery pack.
If the window is locked,
remove the interior cover
and screws to access
the battery pack.
You can now slide
up the window for
more convenient
access to the
programming
buttons and the
battery pack
while the cover
is installed.
window
F
For easy
access to the
battery pack,
unlock the
window by
removing the
security screw.
inside view of
interior cover
X
Install the interior cover
Set locking and unlocking direction
5
6
7
Install 4 AA batteries in battery pack. Make sure the door is open. Press and hold the Program
button. Do not release.
Insert the battery pack and continue
holding the Program button.
A B C D
This step will teach your lock the orientation of your door and is crucial to lock operation.
G
Ensure correct polarity. For best results, use
new, non-rechargeable Alkaline batteries only.
Y
After 3 seconds, release
the Program button.
You will hear the lock beep and
the LED will lash red and green.
Press and release the
Program button again.
The latch bolt will retract and extend
on its own to learn the locking and
unlocking direction of the door.
E F G H
Status LED will
indicate success
or failure.
Success: LED
lashes green
Failure: LED
remains solid red
Note: Latch
bolt will
only retract
half way.
3s
Flashes
red and
green
Loading ...