Loading ...
Loading ...
Loading ...
Note!
The water lines must be fully
inserted into the filter to prevent water
leaking.
Filter Holder
Screw
Installing the water lines of the filter
Please follow the instructions below
and ensure the filter and pipes are
correctly connected to avoid leaks
Installing the water lines and filter
Installing the water filter
To fit the water filter, follow the
installing steps below.
First, take out the water filter and
water lines from the fridge. Second,
determine the location to mount the
external filter. (Note: The water filter
should be mount on the wall where it
is convenient to be replaced, so it is
advised not to mount on the wall
behind the refrigerator.)
Third,
determine the distance
between the filter and the tap, and the
distance from the filter to the fridge.
Prepare lines as required lengths.
(Cut the proper lengths of water lines
which you determine to connect with
the filter inlet or outlet.)
Fourth, mount the filter holder onto the
wall by using a screwdriver, then
attach the water filter.
Warning!
The water filter must be held upright
as shown in the figure above. It is
critical to connect the water inlet and
outlet hoses on the filter correctly.
Never mount the filter onto the
refrigerator. Coolant pipes might be
pierced.
Filter Holder
Filter
Inlet
Outlet
FLOW
First, the 2 clips out, then pull out
the two water filter hygenic caps.
take
Clip
Stopper
Stopper
Water Filter
It is recommended to have a
suitably qualified person to install the
product.
The line length should be less than
5m. If the water line is too long(>5m),
the ice and cold water content may be
affected due to insufficient water
pressure.
Cut the water line as required length
and avoid overbending the water
lines.
9
Loading ...
Loading ...
Loading ...