Loading ...
Loading ...
Loading ...
Before you begin
Read each step thoroughly before proceeding.
CAUTION – Unplug the Refrigerator.
To eliminate the danger of electric shock
during installation, you must unplug the
refrigerator from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
Tools you will need
Parts Included
Icemaker Installation
Remove the outlet cover
Remove the white connector from the upper left
Side
Back
Remove
plug
Remove and discard the white plug
from the lower left back corner of
the freezer wall.
Remove the cover
Use a Phillips head screwdriver to remove the
compressor compartment access cover. This
requires removing six screws which attach the
cover to the back of the refrigerator case.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
Go to the back of the refrigerator. Find the small
label in the upper right corner and remove it
off. Then discard the label.
Install Guide Cab W/Tube A1
Remove
label
Remove one side of the seal paper for
Connect the water line
Make sure there is enough plastic water line to
extend from the water valve to well into the
water tube inlet. Cut off any excess tubing.
Remove
Cap screw
ST
OP
1 2 3 41
7 8
5
6-1
6
No. Part Name Q’ty/Unit
1 CASE ICE MAKER 1
2 SPECIAL C/T BOLT 2
3 BOX ICE 1
4 GUIDE I/WATER 1
5
GUIDE CAB W/TUBE A1 AS
1
6 1
6-1
COVER GUIDE CAB W/TUBE
1
6-2 SEAL W/TUBE A1
2
6-3
VALVE WATER AS
1
6-4
SCREW TAPPING
1
GUIDE CAB W/TUBE A2 AS
GUIDE CAB W/TUBE A1
SCREW TAPPING
11
12
2
1
6-2
6-3
6-4
Seal
Plastic Pipe
corner of the bottom of the freezer.
the water fill tube, slide the seal through
the tube and adhere it to the back edge
of the water tube inlet.
17 34
Loading ...
Loading ...
Loading ...