Loading ...
Loading ...
Loading ...
5
3. Remove the vent card, turn it over and replace it by locating
rear hole in card over locating pin inside air discharge and
reattaching screw at front.
Figure 4
Screw
AIR DIRECTION:
Horizontal louvers on the front grille let you control the air direction
up and down.
Remove the front grille to adjust the vertical louvers side-to-side
to direct the air left or right.
Figure 5
IMPORTANT NOTES:
1. The unit is equipped with a rubber-grommet-mounted
compressor. These grommets are factory set and require
no adjustment.
2. Obstruction to air flow must be checked and removed.
Check the indoor and outdoor grilles for obstructions. The
unit must be located where curtains, furniture, trees, or
other objects do not block air flow to and from the unit. If air
is obstructed and/or deflected back into the unit, the air
conditioner’s compressor may cycle on and off rapidly.
This could cause damage to the compressor.
See following Instructions for re-orienting the Air Discharge
Grille.
AIR DISCHARGE GRILLE
The discharge grille can be adjusted to expel air, as needed.
As shipped
After 180° rotation
Discharge Grille Orientation Options
Use the following procedure to change the angle of the discharge
air flow:
1. Remove the front cabinet (see Front Removal).
2. Position the front so the hinge pins are accessible.
Loading ...
Loading ...
Loading ...