Loading ...
Loading ...
Loading ...
15
Step2: Connect the Speakers
Standard Connections (Pages 8 to 12)
Connect 12345678 for a 7.1 channel system.
Connect 1234569: for a 5.1.2 channel system. Up
to two powered subwoofers can be connected. The same
signal is output from each of the SUBWOOFER PRE OUT
jacks.
0
You can also connect both
78
and
9:
. However, you can
only output audio from one of these at a time. When both
are connected, you can switch which speakers to prioritize.
Press on the remote control (P6) and use "Other" -
"Speakers" to switch between surround back speakers and
height speakers and to switch speakers A and B.
Make sure the exposed wires of the speakers do
not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers
touch the rear panel or the + and – wires touch
each other, the protection circuit will be activated.
> Before Start > Part Names >Install > Initial Setup > Playback
a
b
OR
Speaker B
1/2˝
(12 mm)
a Speaker cable, b Subwoofer cable
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" in Initial Setup (P23).
0
If any of the connected speakers have an impedance of
4 Ω or more to less than 6 Ω, after completing Initial
Setup, you need to make some settings in the System
Setup menu. Press on the remote controller, and in
the Home displayed set "System Setup" - "Speaker" -
"Configuration" - "Speaker Impedance" to "4ohms".
En
SN29403015A_VSX-LX302_BAS_En_1711xx.book 15 ページ ２０１７年１０月２７日 金曜日 午後２時０分
Loading ...
Loading ...
Loading ...