Loading ...
Loading ...
Loading ...
12 13
Operating Instructions
Storm Window Requirements
A storm window frame will not allow the air conditioner to tilt properly which in turn will keep it from
draining properly. To adjust for this, attach a board or piece of wood to the sill. The board or wood piece
should have a depth of at least 1/2”. Make sure the board or piece of wood is approximately 1/2” higher
than the storm window frame. This will allow the air conditioner to tilt enough for proper drainage. (15K
See FIG.1 ).
Prior to Installing the Air Conditioner
1. Check for anything that could block airow. Check the area outside of the window for things such
as shrubs, trees, or awnings. Check the inside area to make sure curtains, drapes, or blinds will not
prevent proper airow.
2. Check the available electrical outlet. The power supply must be the same as shown on the unit
serial nameplate (located on the left side of the unit, near the front faceplate). Be sure the outlet is
close enough for the power cord to reach.
3. Carefully unpack the air conditioner. Remove all packing material and make sure the oor is
protected when removing. Due to the large size of this air conditioner, two people should move the
unit together.
WARNING
When handling the unit, be careful to avoid cuts from the sharp metal edges and aluminum ns on the
front and rear coils.
Operating Instructions
INSTALLATION &ASSEMBLY INSTRUCTIONS -WINDOW MOUNTING
REMOVE CHASSIS
1. Pull down the front panel and lift upwards. Place to the side (FIG.2).
FIG.2
Front panel
Remove filter
2. Remove the lter.
3. Locate the four faceplate screws and remove. These screws will need to be re-installed prior to
mounting the air conditioner (FIG.3).
4. After removing the screws, gently pull away the faceplate from the air conditioner cabinet (FIG.4).
Loading ...
Loading ...
Loading ...