User Manual GE® GFP1528SNWW 27.9" White Laundry Pedestal

• Owner's manual - (English, French, Spanish)

Table of contents

• PREPARE THE PEDESTAL/RISER
• PREPARE THE UNIT
• ATTACH PEDESTAL/RISER TO UNIT

User Manual Pedestal

PREPARE THE PEDESTAL/RISER

INSTALL REAR PEDESTAL/RISER BRACKETS

FOR DRYER AND 32" WASHER

Align rear pedestal/riser bracket as shown on both sides

FOR 34" WASHER

Install pedestal/riser bracket rotated 180° from dryer configuration.

INSTALL FRONT PEDESTAL BRACKETS

Install front pedestal/riser brackets on both sides.

PREPARE THE UNIT

INSTALL WASHER/DRYER BRACKETS

Front Brackets

• Lay the unit on its back on a protective surface.
• Ensure leveling legs are threaded in to minimum height position.
• Install front brackets on the bottom of the washer or dryer as shown. Use the 2 holes closest to the front and the 2 outermost holes on the bracket. The bracket should not go beyond the edge of the appliance.

Rear Brackets

• Install rear brackets on the bottom of the washer or dryer as shown above. Use the top 2 holes on the bottom of the appliance with the tab on the bracket facing the outside.

ATTACH PEDESTAL/RISER TO UNIT

JOIN REAR BRACKETS

• Lift pedestal/riser and hook front brackets of pedestal/riser to front brackets of washer or dryer.
• Align rear brackets on washer or dryer with rear brackets on pedestal/riser and fasten with screws. Make sure the bracket from the appliance is to the INSIDE of the pedestal/riser bracket and not the outside.

LEVEL THE WASHER OR DRYER

• Locate the 4 legs from the parts package and install to minimum height.
• Stand the washer or dryer upright.
• Make sure that the washer or dryer is level by placing a spirit level on top. Check side to side and front to back.
• Use a 5/8" open ended wrench to adjust the legs in and out. Tighten the lock nut against the bottom of the pedestal/ riser.

NOTE: To minimize vibration, the locking nuts must be tight.

JOIN FRONT BRACKETS

• Fasten screw between front brackets for pedestal/riser and washer or dryer on both sides of unit.

WASHING MACHINE ONLY: REMOVE SHIPPING SCREWS

Remove the 4 shipping bolts on the back side of the unit.

FINALIZE THE INSTALLATION

Refer to the washer or dryer installation instructions to complete the installation.

KIT CONTAINS

• Pedestal or Riser

• Drawer Divider (Pedestal Kit Only)

• Pedestal or Riser Brackets - 2 each

Or

• Installation Screws (#8-18 x 7/16) - 22

• Washer/Dryer Brackets - 2 each

TOOLS YOU WILL NEED

IMPORTANT: Shipping bolts should remain in place during installation.