Loading ...
Loading ...
Loading ...
SIDE BURNER ACCESSORY CARE & USE/INSTALLATION
|
19
SAFETY PRACTICES AND PRECAUTIONS
Ensure that burner ties and all packing materials are removed
before lighting any new accessory.
AT EACH NEW SEASON
At the start of each new grilling season you should remove the
cooking grates and check the burners, venturis, ori ces and
valves for obstructions.
Spiders and insects often nest in these areas of the accessory
and can disrupt air ow, causing damage to the accessory
and personal injury.
Also, check all hoses and ttings for damage, abrasion, wear and
tear and repair, if necessary, before turning the gas on.
Replacement pressure regulators and hose assemblies, must be
the type speci ed by Viking Range, LLC. The pressure regulator
and hose assembly supplied with the unit must be used.
If the unit is LP, screw the regulator into the tank and leak check
the hose and regulator connections with a soap and water
solution before operating the burner. Turn all knobs to OFF then
SLOWLY turn on the gas supply valve.
Do not use any grill accessory if you smell gas.
PURGING THE GAS LINES
You should purge the gas line of air before attempting to light
the grill accessory.
1. Make sure all grill controls are in the “OFF” position.
2. Slowly turn on the main gas supply.
3. Push in the control knob for the burner furthest from the
fuel source. Using the burner furthest from the fuel source
will completely purge the lines. It will take several seconds
for the burner to light.
4. Hold the knob ON for about 20 seconds to allow the air in
the system to purge and the burner to light
5. Wait at least 5 minutes after shutting o the control before
attempting to light the burners.
MATCH LIGHTING
If a burner fails to light after several attempts, it can be match
lit. If you’ve just attempted to light the burner with the igniter,
allow 5 minutes for any accumulated gas to dissipate before
match lighting.
Make sure all knobs are in the OFF position. Keep your face as
far away from the burner as possible.
Using the manual lighting rod, pass a lit match over the ports of
the burner. The power burner features a lighting rod as shown
above.
Push and turn the control knob of the burner to ‘Lite”. If the
burner does not light in 4 seconds, turn the knob o and wait 5
minutes before attempting again.
L
IGHTING IN
S
TR
UC
TI
O
N
S
F
O
R ALL A
CC
E
SSO
RIE
S
Read the ‘User Manual/Installation Instructions care-
fully and completely before using your grill or grill
accessory to reduce the risk of re, burn hazard or
other injury.
WARNING
Loading ...
Loading ...
Loading ...