Loading ...
Loading ...
Loading ...
To maintain performances of your unit, you should clean the upper and lower grilles of the unit about twice a year using a
vacuum cleaner or a brush.
Have a professional check the inside of the unit every ve years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is due to the poor quality of the
ambient air. In this case, it is recommended to check that the room is well ventilated (ventilation, air inlet, etc.), and that the
air is clean. The unit will not be replaced under the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.
If the unit does not heat :
Check that the programmer is in COMFORT mode (electronical).
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you have one) has not switched
off the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders : (version with pilot wire)
Make sure that the programming unit is being correctly used (refer to its user’s manual) or that the Chronopass is properly
inserted in its housing and that it is operating normally (batteries ?).
The unit is permanently heating :
Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be distribued by some severe mains voltage distur-
bances (outside EC standards dening the disturbance protection level). If there are any problems (thermostat blocked, etc.)
switch off the unit power supply (fuse, circuit breaker, etc.) for about 5 minutes to allow the unit to start again.
Have your energy distributor check your power supply if the phenomenon occurs frequently.
MAINTENANCE
TROUBLE-SHOOTING
WARRANTY CONDITIONS :
KEEP THIS DOCUMENT IN A SAFE PLACE
(This certicate should only be produced if you are making a complaint, attached with the invoice of the purchase)
- This guarantee is applicable for 7 years from the date of original purchase.
- Your Atlantic distributor will exchange parts shown to be defective in manufacture. The replacement parts will be of charge but Atlantic does not
accept responsability for freight or labor charges or losses in transit.
- This guarantee excludes damage by neglect, shipping or accident and any damage due to incorrect installation, use or purposes other than those
intended or failure to observe the instructions.
- Atlantic Australasia Pty Ltd reserves the right to reject any warranty claims used in conditions other than domestic purposes or connected to non
Australasia and New Zealand approved power boards, extension leads, double adaptors and power outlets.
* This information is shown on the plate which can be seen on the left-side or behind the front grille of the unit.
INSTALLER’S STAMP
UNIT TYPE * :
SERIAL NUMBER * :
CUSTOMER’S NAME AND ADRESS :
FOR SALES IN NEW ZEALAND
ATLANTIC AUSTRALASIA - Phone : 0800 422 000 - Fax : 04 38 00 509
Web : www.atlantics.co.nz - Email : [email protected]
FOR SALES IN AUSTRALIA
ATLANTIC AUSTRALIA Pty Ltd
4/13-25 Church Street
Hawthorn Victoria Street – Australia
Free call : 18 00 67 78 57
Phone :03 98 52 95 99 - Fax : 03 98 52 98 44
Web : www.atlantics.com.au
Email : [email protected] - web : www.atlantics.com.au
Children must not lean on the appliance. Under certain circumstances, there is a risk that its surface may cause
burns to the skin of young children. If there is any risk of this at all, install a protection grill. This device is not
intended for use by persons (including children) with physical, sensory or mental disability, or by persons
lacking experience or knowledge, unless they have received from a person in charge of their safety adequate
supervision or preliminary instructions on how to use the device.
Care must be taken at all times to keep children from playing with the device.
Do not introduce objects or paper into the device.
Do not totally or partially block the grilles on the front or inside of the appliance, as this may cause overheating. If
the supply cord is damaged, it must be replaced by a service agent or similarly qualied person in order to avoid
a hazard (applies to all units). All work to the inside of the appliance must be carried out by a licensed electrician.
WARNINGS
Loading ...
Loading ...