Loading ...
Loading ...
Loading ...
9
After installation of the shield the clearance around the
top and sides of shield will allow adequate ventilation.
Ensure the side and top clearances are not obstructed.
If an oven is positioned below the cooktop the barrier
does not need to be fitted, but a space of 35 mm must
be maintained between the underside of the cooktop and
the top of the oven.
A space of 5 mm must be maintained between the
benchtop and the top front part of the oven. See Fig. 2.
Installation of cooktop
into the kitchen bench
Installation procedure:
Side clearances: If the distance measured from the
periphery of the nearest burner to any vertical surface is
less than 200 mm, the surface shall be protected in
accordance with clauses 6.10.1.2 of AS/NZS 5601.1
1. For cutout dimensions and clearances refer Fig.1.
2. The clips and the adhesive seal (underside of the
cooktop), Fig. 3, are already fitted (depending on the
model), do not under any circumstances remove them.
The seal ensures that the entire work surface will be
watertight, and prevents water seepage. In order to fit the
appliance into the kitchen unit, first place the cooktop in
the correct position then loosen each of the clips so that
they all turn freely (it is not necessary to completely undo
them).
Insert and centre the cooktop.
Press the sides of the cooktop until it is supported around
its entire perimeter.
Turn the clips and tighten them fully. Fig. 3.
Fig. 2
Loading ...
Loading ...
Loading ...