Loading ...
Loading ...
Loading ...
HEADLIGHT BEAM INSPECTION
The headlight beam can be adjusted slightly upward or downward. Use the
following procedure to make the adjustment.
Models with a pod
headlight
Models without a pod
headlight
1. Position the vehicle on a level surface with the headlight approximately 7.6 m
(25 ft.) from a wall. Place the transmission in PARK.
2. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3. Start the engine. Turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of the headlight
beam should be 5 cm (2 in.) below the mark on the wall. Include rider weight
on the seat when measuring.
5. 570 / 570 EPS / X2:
The adjustment knob is located on the right side of the headlight pod. Adjust
the beam to the desired position by turning the knob either clockwise or
counter-clockwise.
q
570 SP adjustment screw
125
MAINTENANCE
Loading ...
Loading ...
Loading ...