Loading ...
Loading ...
Loading ...
Please read before beginning installation.
The water connection to your ice and water product can
be self installed. However, it is recommended that you
seek advice from a licensed plumber before commencing
the installation.
Check for water leaks at all water connection points in
the first 2 to 3 hours after installation, and correct it in
case of any water leak. Recheck after 24 hours; if leak
still occurs, it is recommended to contact a licensed
plumber for advice.
Water is to be connected as per diagram below.
(WHE5160SAD shown)
Step 1.
Ensure that the refrigerator
is disconnected from power
supply.
Step 2.
Connect tap fitting to water
supply tap. Tap must be close
to the refrigerator.
Step 3.
Push the tube into tap fitting
past insertion mark.
Step 4.
Connect other end of tube to inlet on rear of refrigerator.
Step 5.
Turn on water and check all
joints and tubes for leaks.
Step 6.
Reconnect the power.
Step 7.
Move the refrigerator back into place being careful not to
kink or split the tubing.
Step 8.
Switch ON Water Dispenser.
By referring to Ice&Water on/off
function on page no.21
Using a large container, run the
water dispenser to clear air from lines. This may take a
few minutes. Purge and dispense a minimum of 2 litres of
water. Initial water may be black in
colour. This is residual carbon dust
from the filter and is non-toxic.
If the water is slow to shut off or
the dispenser is dripping, air may
still be in the lines. Either purge
more water through the system
to remove this air or allow some
time for the air to be removed
over subsequent dispensing. For
normal use, water dispenser will
automatically shut off after 2
minutes of continuous operation.
As the water cut off is not instant, leave glass under
dispenser briefly until water has stopped flowing to
avoid spills.
Clean and empty the dispenser drip tray regularly to
avoid overflow.
If you have not used the dispenser for some time, discard
the first seven or eight cups of water (contaminants
could have settled in the water pipes).
Step 9
Switch ON Ice Maker.
Once the refrigerator has been running for at least 24
hours remove the ice bin and dispose of the first few
batches of ice to ensure that impurities have been flushed
from the system.
Water dispenser should not be used for extended periods
of time. After 2 minutes of continuous use the water
dispenser will automatically shut off.
Party Ice
When the Ice Bin is removed from the cabinet the
Auto Ice Maker will continue to dispense ice into the top
freezer drawer.
IMPORTANT
IMPORTANT
CAUTION
INSTALLATION 15
Loading ...
Loading ...
Loading ...