Loading ...
Loading ...
Loading ...
INSTALLING YOUR NEW
APPLIANCE
Unpacking
Most of the packing materials are recyclable. Please
dispose of those materials through your local recycling
depot or by placing them in appropriate collection
containers.
Important – check for any damages or marks. If you find
the refrigerator is damaged or marked, you must report
it within 7 days should you wish to claim for damage/
marks under the manufacturers warranty. This does not
affect your statutory rights.
Clean your refrigerator thoroughly following the
instructions in the “Cleaning” section and wipe off any
dust that has accumulated during shipping.
Locating the refrigerator
Automatic aerosol systems (such as insect control)
should not be located adjacent to the product as the
spray may cause long term damage to the external
plastics of the appliance.
Do not put the refrigerator in a location that is too cold or
is unprotected, for example in a garage or on a veranda.
The ambient temperature should be above 10°C.
Put the refrigerator in a dry place avoiding areas of high
moisture or humidity.
Ensure the refrigerator is located on an even surface.
Adequate ventilation around your refrigerator with
the exception of WHE6000, WHE6060, WQE6000
and WQE6060
The diagram below shows the recommended airspace to
allow for ventilation of your refrigerator.
350mm
50mm
Recommended
minimum
airspace
CABINET
DOOR
30mm
30mm
X
Y
If you have a cupboard above the refrigerator with a
rear gap of less than 100 mm (Y), recommended
clearance at the top of the refrigerator increases
from 30mm to 70mm (X) minimum.
Adequate ventilation around your refrigerator
WHE6000, WHE6060, WQE6000 and WQE6060
The diagram below shows the recommended airspace to
allow for ventilation of your refrigerator.
350mm
X
Y
50mm
Recommended
minimum
airspace
CABINET
DOOR
5mm
5mm
If you have a cupboard above the refrigerator with a rear
gap of less than 100 mm (Y) , recommended clearance at
the top of the refrigerator increases from 30mm to 70mm
(X) minimum.
When positioned in a corner area, spacing of at least
350mm on the hinge side will allow the doors to open
enough to enable the removal of bins and shelves.
NOTE: Doors are designed to sit proud of cabinetry (not
flush). The clearances shown above are the recommended
minimum clearances.
The clearance at the rear should not exceed 75mm.
Installing your refrigerator
1. Roll the refrigerator into place.
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and the
rollers. Before moving your refrigerator ensure height
adjusting nut and the stability foot are fully wound up
off the floor.
2. Wind the large height adjusting nut under door hinge
down until the refrigerator is tilted back by 10mm
(see diagram).
Height adjusting nut
Fixed rear rollers
10 -15mm
3. Wind the large height adjusting nut on the handle
side down until the refrigerator is level and stable.
If you have difficulty winding the nut or height
adjusting foot down, have someone tilt the
refrigerator back so you have better access.
stability foot
wound up
ENVIRONMENT
CAUTION
INSTALLATION 13
Loading ...
Loading ...
Loading ...