Loading ...
Loading ...
Loading ...
Page 7
SET UP & USE
OPERATING INSTRUCTIONS
Remove the humidifier from the packing carton and place it upright on an even surface.
NOTE: Only operate heater in upright position. Always make sure the water tank is clean.
Fill with cool water.
1. Remove the water tank from the humidifier base. Remove the cap by turning it
counterclockwise. Fill the entire tank with clean, cool water. After filling with fresh,
distilled, or demineralized water make sure the cap is tightened and water tank is
securely in place over the base of the unit. Make sure the lid is in place on top of the
unit.
2. Connect the power plug and turn the humidity control knob to the right (clockwise)
direction to the ON position for the minimum mist output. To increase humidity you can
turn the knob all the way to the (MAX) position. To decrease the humidity level turn
the knob to the left (counterclockwise)
CAUTION: Do not move the humidifier after the humidifier has been filled with water.
This can cause too much water to spill into the humidifier base.
The green humidity light will illuminate and the humidifier will begin to produce mist.
Once the water in the water tank is too low the humidity/refill light will turn red. The
humidifier will stop working. Clean the water tank and empty any water from the base
before refilling. Once the water tank is refilled the humidifier will resume operation.
NOTE: Never operate the unit when ther is no water in the water tank. To shut the
humidifier o at any time, turn the humidity control knob counterclockwise to
the OFF position.
Loading ...
Loading ...
Loading ...