Loading ...
Loading ...
Loading ...
30_ troubleshooting and information codes
troubleshooting and
information codes
INFORMATION CODES
Information codes may be displayed to help you better understand what is occurring with your Washer.
CODE SYMBOL MEANING SOLUTION
Unbalanced load prevented your
Washer from spinning.
Redistribute the load, press the Start/Pause
Button.
Door is open when Washer is
running.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Your Washer failed to lock the
door.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Water temperature control
problem.
(Heater Control problem)
Call for service.
Your Washer has tried to fi ll but
has not reached the proper water
level.
Call for service.
The door will not unlock. Make sure the door is fi rmly closed.
Push the Power button to turn off your Washer,
then turn it on again. If the code reappears, call
for service.
Motor not running properly. Restart the cycle pressing the Start/Pause
Button. If the code reappears, call for service.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
First of all, clean up the drain fi lter. Then
check the following.
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
Clean the debris fi lter.
If it still does not drain, call for service.
Your Washer has tried to fi ll but
was unsuccessful.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fi ll hoses.
If you use a Flood Safety Device, then please
remove the device and connect the water hoses
directly to the unit.
Check if the hot water supply
hose is connected.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function if the
temperature of the cold water is lower than 59°F.
The hot/cold water hose
connection is not correct.
Please connect the hot/cold water hose
connection correctly.
Electric service was lost when
Washer was running.
Restart the cycle by pressing the Start/Pause
Button.
WF231ANW-02832D_EN.indd Sec10:30WF231ANW-02832D_EN.indd Sec10:30 2011-04-18 10:38:302011-04-18 10:38:30
Loading ...
Loading ...
Loading ...